Firmware User Manual
72
To setup SMTP servers, make sure to enable the SMTP account and choose the proper Authentication
type. There are many types available. The default is Login. We recommend you to use Auto Detection.
Available authentication types include: Auto Detection, None, Login, Plain, Cram MD5, Digest MD5 and
PoP Relay. Please also enter the User Name, Password, the email address displayed as sender (can be
different than the user name), Network (SMTP server) address, Network (SMTP server) Port number and
Max Connection time before timeout (in seconds).
After changing any of the items above, press Apply to save the changes. The Reset button undoes the
changes that had just been made but not applied yet.
HTTP Server
HTTP CGI servers are programs that run on web sites or many devices. They can be custom programmed
to perform a large variety of actions based upon the input. You can define which CGI server to connect to
here, and the user / password required to log into the target server. The actual message / command is
setup in the Notification messages / URL commands section. You may define two separate CGI servers.
IP devices are also CGI servers. This means that IP devices can now issue commands to each other, which
creates endless possibilities for highly coordinated response. The IP device can also give a loopback
command to itself, in effect changing almost all possible settings dynamically. For detail on the
commands used to control the cameras, please contact your customer representative.
An example will help you gain a better sense of how to utilize this unique function. Camera A is a fixed
camera that looks at a corridor leading to the main hall. It has a motion detection window located near
the point where the corridor arrives at the large hall. Camera B is a PTZ camera located in the hall, which
is usually left on auto-tour patrol. When motion activity in the motion detection region triggers MD1 in
Camera A, this then in turn activates an event rule in Camera A that gives out a command to Camera B.
Camera B would then swivel to the preset point where the corridor leads into the entrance and switch to
higher bit rate to temporarily provide clearer image. After the event ends, Camera B will go back to its
normal routine in lower bit rate.
(101 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern